偏滤器靶板磁预鞘层边界的离子流

利用流体力学模型研究了偏滤器等离子体条件下磁预鞘层边界离子流和预鞘层宽度之间的关系，并分析了粒子碰撞对预鞘层边界离子流的影响。由于粒子碰撞对离子的驱动效益，预鞘层边界离子流速度随着预鞘层宽度的增加而减少；只有当预鞘层宽度趋于零时，边界离子流沿磁力线的速度才趋近于离子声速。在固定预鞘层宽度的条件下，计算了预鞘层边界离子流速度与碰撞频率之间的函数关系。     

Load-Carrying Capacity of Circular Plates Made of a Fiber-Reinforced Composite

The load-carrying capacity of circular plates made of a fiber-reinforced composite and loaded with axisymmetric transverse forces under axisymmetric boundary conditions is investigated. The plates can be freely supported or clamped along their contour. To the known yield condition used, in the plane of main bending moments, there correspond irregular hexagons, which depend on the mechanical properties of composite constituents and some characteristic geometrical parameters. It is shown that, depending on the ratio of ultimate radial and circumferential bending moments, in the plastic state, the circular plates (the central part of the clamped plates) take the form of a cone or a frustum of cone. For each of the cases, the limit load is found, which is a function of the above-mentioned mechanical parameters. The statically allowable fields of bending moments and the corresponding allowable fields of deflection rates are determined. The solutions found are exact. Special cases for the freely supported plates are analyzed, and the results obtained are presented in the form of graphs.__________Translated from Mekhanika Kompozitnykh Materialov, Vol. 41, No. 2, pp. 177–192, March–April, 2005.     

轴流泵端壁区域流动三维粘性数值计算

本文采用通用流场分析软件FLUENT,基于N-S方程,选用RNG κ—ε湍流模型与SIMPLEC算法,对轴流泵叶轮内部(及端壁间隙)流动进行了三维粘性数值计算。通过实验验证,表明数值计算结果和实测数据吻合较好。详细分析了叶顶附近流场形态以及叶轮出口轴向、周向速度分布,进行了性能预估。并给出了实验装置图。     

多排叶片内部流动以及叶片排与排气系统相互作用研究

本文采用高分辨率格式和多块多网格方法求解雷诺平均Navier-Stokes方程,数值模拟多排叶片内的三维粘性流动;使用数值激盘模拟叶片排的存在,研究叶片排与非轴对称排气部件之间的相互作用以及复杂的内部流动。文中描述了数值方法,给出了NASA透平导叶和单级透平内部流场的数值结果及其与相应实验结果的对比,也给出了多级透平内部流场的数值结果,以及透平与排气部件之间的耦合流场的结果。     

Homogenization of two-phase flow: high contrast of phase permeabilityHomogénéisation d'écoulement diphasique : grand contraste de perméabilité d'une phase

The steady-state two-phase flow non-linear equation is considered in the case when one of phases has low effective permeability in some periodic set, while on the complementary set it is high; the second phase has no contrast of permeabilities in different zones. A homogenization procedure gives the homogenized model with macroscopic effective permeability of the second phase depending on the gradient and on the second order derivatives of the macroscopic pressure of the first phase. This effect cannot be obtained by classical (one small parameter) homogenization. To cite this article: G.P. Panasenko, G. Virnovsky, C. R. Mecanique 331 (2003).     

Finite element computations of two-dimensional arterial flow in the presence of a transverse magnetic field

A finite element solution of the Navier-Stokes equations for steady flow under the magnetic effect through a double-branched two-dimensional section of a three-dimensional model of the canine aorta is discussed. The numerical scheme involves transforming the physical co-ordinates to a curvilinear boundary-fitted co-ordinate system. The shear stress at the wall is calculated for a Reynolds number of 1000 with the branch-to-main aortic flow rate ratio as a parameter. The results are compared with earlier works involving experimental data and found to be in reasonable qualitative agreement. The steady flow, shear stress and branch flow under the effect of a magnetic field have been discussed in detail.     

Noise Path Synthesis with Nonlinear Joints

An efficient synthesis approach is developed which permits thecalculation of the steady-state frequency response of an assembly whichis comprised of linear components and nonlinear joints. Receptancematrices are used to characterize the linear components, which permitscondensation of the system to just the joint degrees-of-freedom.Furthermore, the calculated nonlinear joint forces are then used tostudy the power flow in the assembly, as well as detailed dynamicbehavior within the components. Integrated into the technique is acontinuation scheme which permits efficient parametric studies.     

Formation of Supersonic Zones and Local Separation Zones in Transonic Steady-State Flow Past Surface Roughness in the Free Interaction Regime

Within the framework of free interaction theory numerical methods are used to investigate the occurrence of supersonic zones with shocks in the outer inviscid region for flow past roughness in the lower viscous sublayer, with and without the formation of local separation zones.     

Heat transfer in lattice BGK modeled fluid

The thermal lattice BGK model is a recently suggested numerical tool aiming at solving problems of thermohydrodynamics. The quality of the lattice BGK simulation is checked in this paper by calculating temperature profiles in the Couette flow under different Eckert and Mach numbers. A revised lower order model is proposed to improve the accuracy and the higher order model is proved to be advantageous in this respect, especially in the flow regime with a higher Mach number.     

On the departure process of a leaky bucket system with long-range dependent input traffic

Due to the strong experimental evidence that the traffic to be offered to future broadband networks will display long-range dependence, it is important to study the possible implications that such traffic may have for the design and performance of these networks. In particular, an important question is whether the offered traffic preserves its long-range dependent nature after passing through a policing mechanism at the interface of the network. One of the proposed solutions for flow control in the context of the emerging ATM standard is the so-called leaky bucket scheme. In this paper we consider a leaky bucket system with long-range dependent input traffic. We adopt the following popular model for long-range dependent traffic: Time is discrete. At each unit time a random number of sessions is initiated, having the distribution of a Poisson random variable with mean λ. Each of these sessions has a random duration τ, where the integer random variable τ has finite mean, infinite variance, and a regularly varying tail, i.e., P(τ >К) ~ К^-Lα L(К), where 1 < α < 2 L(·) is a slowly varying function. Once a session is initiated, it generates one cell at each unit of time until its termination. We examine the departure process of the leaky bucket policing mechanism driven by such an arrival process, and show that it too is long-range dependent for any token buffer size and any - finite or infinite - cell buffer size. Moreover, upper and lower bounds for the covariance sequence of the output process are established. The above results demonstrate that long-range dependence cannot be removed by the kinds of flow control schemes that are currently being envisioned for broadband networks. This revised version was published online in June 2006 with corrections to the Cover Date.